• 0 Posts
  • 78 Comments
Joined 1 year ago
cake
Cake day: July 29th, 2023

help-circle

  • toddestan@lemm.eetomemes@lemmy.worldFridges never die.
    link
    fedilink
    arrow-up
    1
    ·
    edit-2
    7 days ago

    Depends on how old it is. Mine’s a 1995 model. I’ve measured its energy usage and a new fridge would pay for itself at around 9-10 years if I bought a basic model*. That’s around the lifespan I’d expect from a new fridge. So I’ll just keep using the old one until it dies.

    (*) Current fridge is a basic, low end model, so assuming I replace with a similar basic, lower end model. Payback would be much longer if I upgraded.










  • DDG has also really gone downhill for me. It’s still noticeably better than Google, but DDG nows does a lot of the same shit that originally made me give up on Google years ago. I’m assuming a big part of this is because DDG heavily sources their results from Bing, and while Bing does manage to be better than Google, it’s not much better.

    I really need to put some effort into trying out a few more search engines and seeing if they are any better. Last time I looked, many of them were also pulling results from Bing so they all had similar issues.


  • toddestan@lemm.eetoMovies@lemmy.worldIs Disney Bad at Star Wars? An Analysis
    link
    fedilink
    English
    arrow-up
    10
    arrow-down
    1
    ·
    1 month ago

    It’s just typical Disney. Take a popular franchise, and then milk it for everything its worth. To Disney it’s not “bad” if it’s bringing in more money than it cost to make it. Sure, some of it maybe didn’t make as much money as they would have liked, but I don’t believe Disney has actually lost money on any of it (ignoring the Hollywood accounting tricks). So expect Disney to just keep cranking Stars Wars stuff out until everyone is thoroughly bored with it.


  • Other than hoarding up the houses, everything is pretty general Monopoly strategy I figured out a long time ago. Basically try to get a monopoly ASAP and then develop it ASAP. I’ve found that strategy to be good, but it depends a lot on luck. Sometimes despite everything you try, the only monopoly you can get are those horrid green properties and you’re pretty much doomed.



  • What they are doing is comparing your answer and seeing if it is consistent with how it has been answered previously. They realize that not everyone is going to give the exact same answer, so as long as you answer it in a way that enough other people have answered it, it should let you in.

    I’ll usually go with the minimum number of clicks that I think will get me through, since I’m lazy and it’ll also at times slow down how fast you can click which is annoying.

    I’ll also answer them wrong if I think it’s a mistake that enough other people will make. “Yes… that RV over there is a bus…”



  • aren’t you still limited by ambient air temp because the hot side of the Peltier needs to be cooled by air anyway?

    You can certainly get subambient. Put some electrical current through a Peltier and one side gets cold, and the other side gets hot. Use the cold side to cool your components, and get the heat away from the hot side, and you can make it work.

    It can be a bit tricky. The hot side is right next to the cold side and it gets really hot, so if you can’t get the heat away it’ll leak right back over. Peltiers use a lot of power so you need a beefy power supply, and that’ll be another source of heat. Assuming you can figure that all out, you also have to be careful that the cold side doesn’t get too cold or you get condensation. Electrical components tend to not like moisture very much.

    I remember people experimented around with it back in early-mid 2000’s. General consensus nowadays seems to be is that it’s not terribly effective or practical and not worth the trouble.